Ps-engineering PAR200 Manuel d'utilisateur télécharger pdf (Page 8)

PS Engineering Inc. ®

PAR200 Audio Selector Panel, COM radio Controller and Intercom System

Installation and Operator’s Manual

200-228-0000 Page 2-1 Rev. 4, Dec. 2013

Section II - INSTALLATION

2.1 GENERAL INFORMATION

2.1.1 SCOPE

This section provides detailed installation and interconnection instructions for the PS Engineering

PAR200 Audio Selector Panel/Intercom/ with VHF communication radio controls.

Please read this manual carefully before beginning any installation to prevent damage and post-

installation problems. Installation of this equipment requires special tools and knowledge.

2.1.2 Certification Requirements

NOTE

The PAR200 Intercom is FAA approved under TSO C139 (Aircraft Audio Systems and Equipment) and

contains partial elements of TSO C169a (VHF Radio Communications Transceiver Equipment Operating

Within Radio Frequency Range 117.975 To 137.000 Megahertz).

The partial TSO applies to C169a, because the PAR200 unit provides control and display only for the

TY91-series of VHF communications equipment.

The conditions and tests for TSO approval of this article are minimum performance standards. Those

installing this article, on or in a specific type or class of aircraft, must determine that the aircraft in-

stallation conditions are within the TSO standards.

The article may be installed only following 14 CFR Part 43 or the applicable airworthiness require-

ments.

2.2 Unpacking and Preliminary Inspection

Use care when unpacking the equipment. Inspect the units and parts supplied for visible signs of shipping

damage. Examine the unit for loose or broken buttons, bent knobs, etc. Verify the correct quantity of

components supplied with the list in Section 1.6 (B). If any claim is to be made, save the shipping mate-

rial and contact the freight carrier. Do NOT return units damaged in shipping to PS Engineering. If the

unit or accessories show any sign of external shipping damage, contact PS Engineering to arrange for a

replacement. Under no circumstances attempt to install a damaged unit in an aircraft. Equipment returned

to PS Engineering for any other reason should be shipped in the original PS Engineering packaging, or

other UPS approved packaging.

2.3 Equipment Installation Procedures

2.3.1 Cooling Requirements

Forced air-cooling of the PAR200 is not required. However, the units should be kept away from heat pro-

ducing sources (i.e. defrost or heater ducts, dropping resistors, heat producing avionics) without adequate

cooling air provided.

2.3.2 Mounting Requirements

The PAR200 must be rigidly mounted to the instrument panel of the aircraft structure, within view and

reach of the pilot position(s). The unit may be mounted in any area where adequate clearance for the unit

and associated wiring bundle exist.

To prevent noise, avoid installing the unit close to high current devices or systems with high-voltage pulse

type outputs, such as DME or transponders. Avoid running the interconnecting bundles near any high

current wires.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 42 43

Commentaires sur ces manuels

Pas de commentaire

Ps-engineering PAR200 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires audio Ps-engineering PAR200