Ps-engineering PAR200 Manuel d'utilisateur télécharger pdf (Page 14)

PS Engineering Inc. ®

PAR200 Audio Selector Panel, COM radio Controller and Intercom System

Installation and Operator’s Manual

200-228-0000 Page 2-7 Rev. 4, Dec. 2013

You can answer a call when you hear the “telephone ringing” in your headset. To answer the phone call

will require you to have access to your phone and selecting the answer function of that telephone. There is

no front panel button that will allow you to answer the phone.

2.6.1 Paring separate music and telephone devices

It is possible to use a different music source (iPad, iPod with Bluetooth adapter, Bluetooth enabled laptop,

etc) and telephone. However, the music source must be paired first, before the telephone, if the telephone

also has music streaming capability. Otherwise, the Smartphone will also take over the music streaming.

Only one can be a phone. If the telephone can provide both telephone and streaming music, when the

phone is connected, it will automatically disconnect the music device. If it is possible to turn off the music

streaming function on the telephone, then both the telephone and a separate Bluetooth® enabled music

device can be use at the same time.

If Bluetooth connections become unreliable or do not connect, you may need to reset the PAR200. Turn

the PAR200 off, press & hold the N1 & N2 buttons while turning the unit back on, continue to hold the

N1 & N2 for 3 seconds.

NOTE

FCC Regulations (47 CFR 22.925) prohibit airborne operation of cellular phones;

Cellular telephones installed in or carried aboard airplanes, balloons or any other type of aircraft must not

be operated while such aircraft are airborne (not touching the ground). When any aircraft leaves the

ground, all cellular telephones on board that aircraft must be turned off. The use of cellular telephones

while aircraft is on the ground is subject to FAA regulations.

FAA Regulation 14 CFR 91.21(5) allows for use of portable electronic devices that the operator of the

aircraft has determined will not cause interference with the navigation or communication system of the

aircraft on which it is to be used.

PS Engineering, Inc. does not endorse using unapproved cellular telephone equipment in flight, and takes

no responsibility for the user’s action. PS Engineering does not guarantee compatibility with personal

cellular telephones. For a list of phones that have been tested, visit www.ps-engineering.com.

2.6.2 Telephone sidetone

The PAR200 will provide cell phone sidetone (your side of the telephone conversation) in the factory con-

figuration. Some telephones do provide sidetone the PAR200 can be configured to remove this sidetone by

placing the DIP switch in the proper configuration.

Cell phone sidetone created by audio panel OFF J5 Switch 6

No cell phone sidetone ON

Table 2-4 Telephone sidetone switch

2.6.3 "Swap" Mode

When a momentary, normally open, push-button switch is connected between pin 20 on the J2 connector

and aircraft ground, the user can switch between Com 1 and 2 by depressing this switch without having to

turn the mic selector switch. This yoke-mounted switch eliminates the need to remove your hands from

the yoke to change transceivers.

2.6.4 Backlighting

The PAR200 has an automatic dimming of the pushbutton annunciation LEDs controlled by a photocell.

Control of the unit backlighting is through the aircraft avionics dimmer. For 12-Volt aircraft, connect J2

Pins 6 and 7 to the aircraft dimmer bus, and pin 5 to ground.

The LCD display backlighting is controlled by the automatic photocell dimming. In addition, the text in-

verts for nighttime mode when the ambient light is low.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 42 43

Commentaires sur ces manuels

Pas de commentaire

Ps-engineering PAR200 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires audio Ps-engineering PAR200